AP440 regulatory compliance statement

Topic

This article contains all regulatory compliance statements for the Datto AP440 Access Point.

Environment

  • Datto AP440 Access Points

Description

Federal Communication Commission Interference Statement

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

FCC Radiation Exposure Statement:

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 22 cm between the radiator & your body.

FCC Cautions: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

This device and it's antennas(s) must not be co‐located or operating in conjunction with any other antenna or transmitter except in accordance with FCC multi‐transmitter product procedures.

For product available in the USA/Canada market, only channel 1~11 can be operated. Selection of other channels is not possible.

Devices will not permit operations on channels 120‐132 for 11a and 11n/a which overlap the 5600 ‐ 5650 MHz band.

The country code selection is for non‐US model only and is not available to all US model. Per FCC regulation, all WiFi product marketed in US must fixed to US operation channels only. Only Trained and Qualified Professionals should be allowed to install, replace or service this equipment. No User‐Serviceable parts inside. To Avoid Risk of electric shock, do not open. Installation of the equipment must comply with local and national electrical codes.

FCC Professional Installation Instructions:

1. Installation Personnel

This product is designed for a specific application and needs to be installed by a qualified professional who has RF and related rule knowledge. The General User shall not attempt to install or change the settings.

2. Installation Location

The product shall be installed at a location where the radiating antenna can be kept 25cm away from nearby person in normal operating condition to meet regulatory RF exposure requirements

3. External Antenna

Use only the antennas which have been approved by the applicant. The nonapproved antenna(s) may produce unwanted spurious or excessive RF emissions which may lead to the violation of FCC limit and is prohibited.

4. Installation Procedure

Please refer to the User’s Manual for the installation procedure details

5. Warning

Please carefully select the installation position and make sure that the final output power does not exceed the limit set in relevant rules. The violation of the rule could lead to serious federal penalty.

Canada, Industry Canada (IC) Notices

This device contains licence‐exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence‐exempt RSS(s). Operation is subject to the following two conditions:

1. This device may not cause interference.

2. This device must accept any interference, including interference that may cause undesired operation of the device.

L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d’Innovation, Sciences et Développement économique Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes :

1. L’appareil ne doit pas produire de brouillage;

2. L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement.

(i) the device for operation in the band 5150‐5250 MHz is only for indoor use to reduce the potential for harmful interference to co‐channel mobile satellite systems;
(ii) where applicable, antenna type(s), antenna models(s), and worst‐case tilt angle(s) necessary to remain compliant with the e.i.r.p. elevation mask requirement set forth in section 6.2.2.3 shall be clearly indicated.

Avertissement:

Le guide d’utilisation des dispositifs pour réseaux locaux doit inclure des instructions précises sur les restrictions susmentionnées, notamment :

(i) les dispositifs fonctionnant dans la bande 5150‐5250 MHz sont réservés uniquement pour une utilisation à l’intérieur afin de réduire les risques de brouillage préjudiciable aux systèmes de satellites mobiles utilisant les mêmes canaux;
(ii) lorsqu’il y a lieu, les types d’antennes (s’il y en a plusieurs), les numéros de modèle de l’antenne et les pires angles d’inclinaison nécessaires pour rester conforme à l’exigence de la

p.i.r.e. applicable au masque d’élévation, énoncée à la section 6.2.2.3, doivent être clairement indiqués

Radiation Exposure Statement:

This equipment complies with ISED radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with greater than 26 cm between the radiator & your body.

Déclaration d'exposition aux radiations:

Cet équipement est conforme aux limites d'exposition aux rayonnements ISED établies pour un environnement non contrôlé. Cet équipement doit être installé et utilisé à plus de 26 cm entre le radiateur et votre corps.

Professional installation instruction

1. Installation personal

This product is designed for specific application and needs to be installed by a qualified personal who has RF and related rule knowledge. The general user shall not attempt to install or change the setting.

2. Installation location

The product shall be installed at a location where the radiating antenna can be kept 26 cm from nearby person in normal operation condition to meet regulatory RF exposure requirement.

3. External antenna

Use only the antennas which have been approved by the applicant. The non‐approved antenna(s) may produce unwanted spurious or excessive RF transmitting power which may lead to the violation of ISED limit and is prohibited.

4. Installation procedure

Please refer to user’s manual for the detail.

5. Warning

Please carefully select the installation position and make sure that the final output power does not exceed the limit set force in relevant rules. The violation of the rule could lead to serious federal penalty.

Instructions d'installation professionnelle

1. Installation

Ce produit est destine a un usage specifique et doit etre installe par un personnel qualifie maitrisant les radiofrequences et les regles s'y rapportant. L'installation et les reglages ne doivent pas etre modifies par l'utilisateur final.

2. Emplacement d'installation

En usage normal, afin de respecter les exigences reglementaires concernant l'exposition aux radiofrequences, ce produit doit etre installe de facon a respecter une distance de 26 cm entre l'antenne emettrice et les personnes.

3. Antenn externe.

Utiliser uniiquement les antennes approuvees par le fabricant. L'utilisation d'autres antennes peut conduire a un niveau de rayonnement essentiel ou non essentiel depassant les niveaux limites definis par ISED, ce qui est interdit.

4. Procedure d'installation

Consulter le manuel d'utilisation.

5. Avertissement

Choisir avec soin la position d'installation et s'assurer que la puissance de sortie ne depasse pas les limites en vigueur. La violation de cette regle peut conduire a de serieuses penalites federales.

Appendix C: Declaration of Conformity

Hereby, Datto, Inc, declares that the radio equipment type AP440 is in compliance with Directive 2014/53/EU issues by the Commission of the European Community. The full text of the EU declaration of conformity is available at the following internet address: helpdesk.kaseya.com

A minimum Separation distance of 20 cm must be maintained between the user's body and the device, including the antenna during body-worn operation to comply with the RF exposure requirements in Europe.

The following Test methods have been applied in order to prove conformity with the essential requirements of the EU Directive 2014/53/EU.

Radio:

  • EN 300 328
  • EN 301 893 RF Exposure:
  • EN 50385
  • EN 62311 EMC:
  • EN 301 489-1
  • EN 301 489-17 Emissions:
  • EN 55024
  • EN 55032
  • EN 55035

Safety:

  • EN 62368-1
  • EN 60950-22
  • IEC 60529

CE Statements

Simplified EU Declaration of Conformity

Cesky[Czech] Datto tímto prohlašuje, že tento bezdrátový přístupový bod AP440 je ve shodě se základními požadavky a dalšími příslušnými ustanoveními směrnice 2014/53 / EU
Dansk[Danish] Datto erklærer hermed, at dette trådløse adgangspunkt AP440 er i overensstemmelse med de væsentlige krav og andre relevante bestemmelser i direktiv 2014/53 / EU
Deutsch[German] Hiermit erklärt Datto, dass dieser drahtlose Zugangspunkt AP440 den grundlegenden Anforderungen und anderen relevanten Bestimmungen der Richtlinie 2014/53 / EU entspricht
Eesti[Estonian] Käesolevaga deklareerib Datto, et see traadita pääsupunkt AP440 on - oluliste nõuete ja muude asjakohaste sätete järgimine Direktiiv 2014/53 / EU
English Hereby, Datto, declares that this wireless Access Point AP440 is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU
Español[Spanish] Por la presente, Datto declara que este punto de acceso inalámbrico AP440 cumple con los requisitos esenciales y otras disposiciones relevantes de la Directiva 2014/53 / EU.
Ελληνική [Greek] Με το παρόν, η Datto, δηλώνει ότι αυτό το ασύρματο σημείο πρόσβασης AP440 συμμορφώνεται με τις βασικές απαιτήσεις και άλλες σχετικές διατάξεις της οδηγίας 2014/53 / ΕU
Français [French] Par la présente, Datto déclare que ce point d'accès sans fil AP440 est conforme aux exigences essentielles et aux autres dispositions pertinentes de la directive 2014/53 / EU.

Italiano[Italian]

Con la presente, Datto, dichiara che questo Access Point wireless AP440 è conforme ai requisiti essenziali e ad altre disposizioni pertinenti della Direttiva 2014/53 / EU.

Latviski[Latvian]

Ar šo Datto paziņo, ka šis bezvadu piekļuves punkts AP440 atbilst Direktīvas 2014/53 / EU pamatprasībām un citiem attiecīgajiem noteikumiem

Lietuvių[Lithuanian]

Šiuo, Datto pareiškia, kad šis belaidis prieigos taškas AP440 atitinka esminius Direktyvos 2014/53 / ES reikalavimus ir kitas susijusias nuostatas

Nederlands[Dutch]

Hierbij verklaart Datto dat dit draadloze toegangspunt AP440 in overeenstemming is met de essentiële vereisten en andere relevante bepalingen van richtlijn 2014/53 / EU

Malti[Maltese]

Hawnhekk, Datto, jiddikjara li dan il-Punt ta 'Aċċess bla fili AP440 huwa konformi mar-rekwiżiti essenzjali u dispożizzjonijiet rilevanti oħra tad-Direttiva 2014/53 / EU

Magyar[Hungarian]

Ezennel a Datto kijelenti, hogy ez az AP440 vezeték nélküli hozzáférési pont megfelel a 2014/53 / EU irányelv alapvető követelményeinek és egyéb vonatkozó rendelkezéseinek

Polski[Polish]

Niniejszym Datto oświadcza, że ten bezprzewodowy punkt dostępowy AP440 jest zgodny z zasadniczymi wymaganiami i innymi odpowiednimi postanowieniami dyrektywy 2014/53 / EU

Português[Portuguese]

Por meio deste, Datto declara que este Ponto de Acesso sem fio AP440 está em conformidade com os requisitos essenciais e outras disposições relevantes da Diretiva 2014/53 / EU

Slovensko [Slovenian]

Datto izjavlja, da je ta brezžična dostopna točka AP440 v skladu z bistvenimi zahtevami in drugimi ustreznimi določbami Direktive 2014/53 / EU

Slovensky [Slovak]

Týmto spoločnosť Datto vyhlasuje, že tento bezdrôtový prístupový bod AP440 je v súlade so základnými požiadavkami a ďalšími príslušnými ustanoveniami smernice 2014/53 / EÚ.

Suomi [Finnish]

Täten Datto vakuuttaa, että tämä langaton tukiasema AP440 on direktiivin 2014/53 / EU olennaisten vaatimusten ja muiden asiaankuuluvien säännösten mukainen.

Svenska [Swedish]

Härmed förklarar Datto att denna trådlösa åtkomstpunkt AP440 överensstämmer med de väsentliga kraven och andra relevanta bestämmelser i direktiv 2014/53 / EU