Setting up the Datto Networking Appliance (DNA)
Topic
This article provides steps to set up your Datto Networking Appliance (DNA).
Environment
- Datto Networking Appliance (DNA)
Description
-
Screw the antennas on to the corresponding WiFi and LTE posts.
-
If you need to rackmount the DNA, complete the process described in Rackmounting a Datto Networking Appliance.
To wall mount the appliance, complete the procedure described in Wall Mounting a Datto Networking Appliance.
-
Plug in the Ethernet cable that's connected to your Internet source into Ethernet WAN port 1.
-
Plug in the 12V DC power supply into the DNA and power on the unit.
-
Check LTE signal strength on the Wall Mounting a Datto Networking Appliance indicator:
- Steady LED: This indicates the DNA is receiving a good LTE signal.
- Blinking LED: This indicates the DNA is receiving a weak LTE signal.
- No LED: This indicates the DNA cannot receive an LTE signal.
-
Open a web browser on any device, navigate to https://dna.datto.com, and log in with your Partner Portal credentials.
-
Proceed to the Accessing Your Appliance section of Datto Networking Appliance (DNA): Getting started to continue.